Clear Spanning-Tree Detected Protocols - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface
Hide thumbs Also See for SCALANCE XM-400:
Table of Contents

Advertisement

show spanning-tree mst
The parameters have the following meaning:
Parameters
instance-id
interface-
type
interface-id
stats
hello-time
detail
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The settings are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the
command.
6.3.2

clear spanning-tree detected protocols

Description
With this command, you restart the protocol transmission process on a specific or on all
interfaces and force renegotiation of the connection settings with the neighboring devices.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
[<instance-id(1-64)>] interface<interface-type><interface-id>
[{stats|hello-time|detail}]
Description
Number of the instance or range of
instances whose settings are displayed
Type or speed of the interface
Slot no. and port no. of the interface
Shows the number of incoming and outgoing
packets for each path of the interface
Shows the intervals at which the root switch
sends its "Hello" message to the other
switches
Shows detailed information about the
selected interface
Network structures
6.3 Spanning Tree
Range of values
1 ... 64
gigabitethernet
extreme-ethernet
Enter a valid interface name
-
-
-
show spanning-tree
191

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scalance xr-500

Table of Contents