Parameter
md5
key
Result
The virtual link is created.
Further notes
You delete the virtual link with the
You display information about the virtual link with the
9.3.13.10
no area virtual-link
Description
With this command, you delete a virtual link.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no area <area-id> virtual-link <router-id>
[authentication]
[hello-interval]
[retransmit-interval]
[transmit-delay]
[dead-interval
[{
}]
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Keyword for the password
Password
authentication-key | message-digest-key <Key-id (0-255)>
command.
no area virtual link
show ip ospf virtual
Layer 3 functions
9.3 OSPFv2
Range of values / note
-
enter the password
Maximum length:
characters
16
command.
381