You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf cost <cost (1-65535)>
The parameter has the following meaning:
Parameter
cost
Result
The costs are specified.
Further notes
You delete the costs with the
You show the configuration of the OSPF interface with the
command.
9.3.14.6
no ip ospf cost
Description
With this command, you delete the costs.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Costs for the OSPF interface
no ip ospf cost
Range of values / note
1 ... 65535
command.
show ip ospf interface
Layer 3 functions
9.3 OSPFv2
403