Permit Tcp - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
Parameter
mask
message-type
type
message-code
code
Result
The IP access list for ICMP messages has been configured.
Note
Subnet mask for individual hosts
If you create the rule for a single system (one IP address), you will need to specify a 32-Bit
long subnet mask. This is then "255.255.255.255". As an alternative, you can specify the
keyword "host" followed by the IP address.
Further notes
You delete an IP access control list with the
command.
You display the configuration of the access control list with the
11.4.3.5

permit tcp

Description
With this command, you configure an IP access control list for the TCP protocol.
You have the following options:
● All incoming and/or outgoing TCP segments are forwarded.
● Incoming and/or outgoing TCP segments of a specific host are forwarded.
● Incoming and/or outgoing TCP segments of hosts of a specific subnet are forwarded.
● Incoming and/or outgoing TCP segments are forwarded to specific ports.
506
Description
Corresponding subnet mask
Keyword for the ICMP message type
ICMP message type
Keyword for the ICMP message code
ICMP message code
Values
IP address and subnet mask.
-
0 ... 255
-
0 ... 255
no ip access-list standard <acl-num>
show access-lists
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.