8.6 Multicast; Show Multicast-Block Config - Siemens SCALANCE XM-400 Configuration Manual

8.6 Multicast
The commands in this section configure the procedures for handling Multicast frames.
The commands allow the following:
● Configuration of groups
● IGMP
● GMRP
● Blocking unknown Multicast frames.
With the "show" commands, you can display the configuration data.
8.6.1

show multicast-block config

Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show multicast-block config[port<interface-type><interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If no parameters are specified, the settings for all ports are displayed.
Result
The multicast blocking settings for ports are displayed.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
Description
Keyword for a port description
Type of interface
Slot no. and port no. of the interface
Layer 2 management protocols

8.6 Multicast

Range of values
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
351