Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

8.6.4.2

mac-address-table static multicast

Description
With this command, you configure a static multicast address.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:bb:cc:dd:ee:ff> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
vlan
address
-
If you do not select any parameters from the parameter list, the default value is used.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The settings for static multicast are configured.
Further notes
You disable the setting with the
4094)>
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Keyword for a VLAN
Keyword for a MAC address
MAC address
command.
no mac-address static multicast <mac-address><vlan-id(1-
Layer 2 management protocols
8.6 Multicast
Range of values / note
1 ... 4094
-
aa:bb:cc:dd:ee:ff
355