Configuration
3.1 System
Syntax
Call up the command with the following parameters:
duplex {full|half}
The parameters have the following meaning:
Parameter
full
half
Result
The duplex mode of the interface is configured.
Further notes
You can reset the duplex mode of the Interface to the default value with the
command.
3.1.11.3
no duplex
Description
With this command, you reset the duplex mode of an interface to the default value.
The default value is
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no duplex
Result
The duplex mode of the Interface is reset to the default value.
Further notes
You configure the duplex mode of the interface with the
68
Description
The Interface will be operated in full duplex mode. Default:
The Interface will be operated in half duplex mode
.
full
full
command.
duplex
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
no duplex