Commands In The Interface Configuration Mode; Rate-Limit Output - Siemens SCALANCE XM-400 Configuration Manual

10.1.2

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
● If you exit the Interface configuration mode with the
10.1.2.1

rate-limit output

Description
With this command, you configure and enable the packet rate for limiting the outgoing data
stream of the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
rate-limit output [rate-value<Mbps(1-80000000)>]
The parameters have the following meaning:
Parameter
rate-value
Mbps
If you do not select any parameters from the parameter list, the default value is used.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Global configuration mode.
Privileged EXEC mode.
Description
Keyword for the value of the packet rate
Value for the packet rate in packets/second
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Load control
10.1 Rate control
Range of values
-
1 ... 80000000
Default:
The packet rate is set to
0.
The outgoing data
stream is not limited.
455