Map Protocol - Siemens SCALANCE XM-400 Configuration Manual

6.1.2.3

map protocol

Description
With this command, you assign a protocol to a protocol group.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
map protocol
The parameters have the following meaning:
Parameter
ip
novell
netbios
appletalk
other
enet-v2
Group id
integer
Result
The protocol group is created.
Further notes
You delete the protocol group with the
You can display the status of this function and other information with the
protocols-group
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
{ip | novell | netbios | appletalk | other <aa:aa>}
enet-v2 protocols-group <Group id integer(1-100)>
Description
Internet Protocol v4
Novell Netware protocol
Netbios via TCP/IP
Appletalk
Other protocol.
Frame structure is Ethernet II
Number of the group
command.
Range of values
HEX 08:00
HEX 81:38
HEX f0:f0
HEX 80:9b
enter the hexadecimal protocol value.
other:
•
aa:aa
IPV6:
•
86:DD
LLDP:
•
88:CC
PTP IEEE1588:
•
EAP (802.1X):
•
-
decimal 0 ... 100
command.
no map protocol
Network structures
6.1 VLAN
88:F7
88:8E
show vlan
151