Standby Connection-Name; No Standby Connection-Name - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.4 Ring redundancy and standby connection
8.4.6.2

standby connection-name

Description
With this command, you assign a name to the standby connection on the device.
Requirement
You are in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
standby connection-name <string(32)>
The parameter has the following meaning:
Parameter
<string(32)>
Result
The standby connection is assigned a name.
8.4.6.3

no standby connection-name

Description
With this command, you delete the name of a standby connection.
Requirement
You are in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call the command without parameters:
no standby connection-name
Result
The name of the standby connection is deleted.
340
Description
Name of the connection
Note
max. 32 characters
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07