Ntp Time Diff - Siemens SCALANCE XM-400 Configuration Manual

5.2.3.3

ntp time diff

Description
With this command, you configure the time difference between the device and the NTP
server.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
ntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Parameter
+
-
hh
mm
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
Result
The time difference between the device and the NTP server is configured.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Time zones to the west of the NTP server time zone
Time zones to the east of the NTP server time zone
Number of hours difference
Number of minutes difference
System time
5.2 NTP client
127