No Syslogserver; Rmon - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics

12.3 RMON

12.2.2.2

no syslogserver

Description
With this command, you delete an entry from the table.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no syslogserver {ipv4 address}
The parameter has the following meaning:
Parameter
ipv4 address
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The entry is deleted from the table.
Further notes
You add an entry with the
12.3 RMON
The RMON function provides commands with which variables of the Management
Information Base (MIB) can be monitored for violation of limit values and to store or forward
these events in the following ways:
● Entry in the local log
● Sending as SNMP trap
570
Description
IP v4 address
command.
syslogserver
Range of values
Enter a valid IPv4 address
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07