No Switchport Mode - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Result
The operating mode is configured.
Further notes
You reset the operating mode to the default with the
You display this setting and other information with the
You configure the interface as a switch port with the
6.1.3.10

no switchport mode

Description
With this command, you reset the operating mode for the switch port to the default.
The default value is Hybrid.
Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport mode
Result
The setting is reset to the default value.
Further notes
You configure the operating mode with the
You display this setting and other information with the
You configure the interface as a switch port with the
194
no switchport mode
show vlan port config
command.
switchport
command.
switchport mode
show vlan port config
command.
switchport
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.
command.