System time
5.3 SNTP Client
5.3.3
Commands in the SNTP configuration mode
This section describes commands that you can call up in the SNTP configuration mode.
In the Global configuration mode, enter the
● If you exit the SNTP configuration mode with the
configuration mode.
● If you exit the SNTP configuration mode with the
Privileged EXEC mode.
5.3.3.1
sntp client addressing-mode
Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
Requirement
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter
unicast
broadcast
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the
You display the settings for the unicast mode with the
command.
You display the settings for the broadcast mode with the
command.
158
sntp
Description
configures the SNTP client in unicast
mode
configures the SNTP client in broad-
cast mode
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command to change to this mode.
command, you return to the Global
exit
command, you return to the
end
Range of values / note
Default: unicast enabled
-
show sntp status
show sntp unicast-mode status
show sntp broadcast-mode status
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.