As Path List Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
AS P L
ATH IST
To activate the Autonomous System (AS) Path List Configuration mode, enter the ip as-path-list
command at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#ip as-path-list listname
ProCurve(config-as-path-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 1435
end on page 1436
exit on page 1437
All other commands for this command set are described in this section in alphabetical order.
deny<community-number> | internet | local-as | no-export | no-advertise]
permit [<community-number> | internet | local-as | no-export | no-advertise]
5991-2114
C S
OMMAND ET
© Copyright 2006 Hewlett-Packard Development Company, L.P.

AS Path List Command Set

on page 1272
on page 1273
1271