Chrysler 2005 Crossfire SRT6 Service Manual page 460

5 - 294 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1212-CAB SYSTEM OVERVOLTAGE (CONTINUED)
3.
MEASURE THE RESISTANCE OF THE GROUND CIRCUIT
Turn the ignition off.
Disconnect the CAB connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance between ground and the Ground circuit at the
CAB harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 4
No >> Repair the Ground circuit for an open.
Perform ABS VERIFICATION TEST.
4.
MEASURE THE RESISTANCE OF THE GROUND CIRCUIT
With the ignition off.
Measure the resistance between ground and the Ground circuit at of
the CAB harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the Ground circuit for an open.
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH