Chrysler 2005 Crossfire SRT6 Service Manual page 446

5 - 280 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1201-BAS RELEASE SWITCH CIRCUIT (CONTINUED)
12.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE BAS RELEASE SWITCH SENSOR
(APPLIED) CIRCUIT WITH CAB CONNECTED
With the ignition off.
Reconnect the CAB harness connector.
Measure the resistance between ground and the BAS Release Switch
Sensor (Applied) circuit at the BAS Brake Booster C2 harness connec-
tor.
Is the resistance 6.5–7.0k ohms?
Yes >> Replace the BAS Release Switch (Brake Booster). (Refer
to 5 -
BRAKE BOOSTER - REMOVAL)
Perform ABS VERIFICATION TEST.
No >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL)
Perform ABS VERIFICATION TEST.
BRAKES/HYDRAULIC/MECHANICAL/POWER
ANTILOCK BRAKE -
ZH