Chrysler 2005 Crossfire SRT6 Service Manual page 425

ZH
1185-BAS TRAVEL SENSOR CIRCUIT (CONTINUED)
2.
MEASURE THE RESISTANCE BETWEEN THE BAS TRAVEL SENSOR SIGNAL CIRCUIT AND THE 5-VOLT
SUPPLY CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the BAS Travel Sensor Signal circuit
and the 5-Volt supply circuit in the BAS Brake Booster C1 harness
connector.
Is the resistance above 100k ohms?
Yes >> Go to 3
No >> Repair the BAS Travel Sensor Signal circuit for a short to
the 5-Volt Supply circuit.
Perform ABS VERIFICATION TEST.
3.
MEASURE THE RESISTANCE OF THE BAS TRAVEL SENSOR SIGNAL CIRCUIT
With the ignition off.
Measure the resistance of the BAS Travel Sensor Signal circuit from
the CAB harness connector to the BAS Brake Booster C1 harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 4
No >> Repair the BAS Travel Sensor Signal circuit for an open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 259