ZH
1174-STEERING ANGLE SENSOR - NOT INITIALIZED (CONTINUED)
2.
MEASURE STEERING ANGLE SENSOR FUSED IGNITION SWITCH OUTPUT CIRCUIT VOLTAGE
With the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
Steering Angle Sensor harness connector.
Is the voltage above 10 volts?
Yes
>> Go to 3
No
>> Repair the Fused Ignition Switch Output circuit for an
open.
Perform ABS VERIFICATION TEST.
3.
VISUALLY INSPECT COMPONENTS FOR DAMAGE AND CORRECT INSTALLATION
Visually inspect the Steering Angle Sensor for damage and correct installation.
Are there any visible Steering Angle Sensor concerns?
Yes
>> Correct the sensor concerns as necessary.
Perform ABS VERIFICATION TEST.
No
>> Replace the Steering Angle Sensor.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 255