Chrysler 2005 Crossfire SRT6 Service Manual page 443

ZH
1201-BAS RELEASE SWITCH CIRCUIT (CONTINUED)
6.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE 12 VOLT SUPPLY CIRCUIT
Turn the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the BAS Release Switch
12 Volt Supply circuit at the BAS Brake Booster C2 harness connector.
Is the resistance above 100k ohms?
Yes >> Go to 7
No >> Repair the BAS Release Switch 12 Volt Supply circuit for a
short to ground.
Perform ABS VERIFICATION TEST.
7.
MEASURE THE RESISTANCE OF THE 12 VOLT SUPPLY CIRCUIT
With the ignition off.
Measure the resistance of the BAS Release Switch 12 Volt Supply cir-
cuit from the BAS Brake Booster C2 harness connector to the CAB
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the BAS Release Switch 12 Volt Supply circuit for
an open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 277
ANTILOCK BRAKE -