Chrysler 2005 Crossfire SRT6 Service Manual page 433

ZH
1187-BAS TRAVEL SENSOR - PLAUSIBILITY ERROR (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition On. The Controller Antilock Brake (CAB) monitors the status of the BAS
Travel Sensor.
• Set Condition: The Controller Antilock Brake (CAB) will set this DTC if the calculated BAS Travel Sensor offset
is out of the specified range.
IMPROPERLY MOUNTED BAS TRAVEL SENSOR
BAS TRAVEL SENSOR
For a complete Antilock Brake System (ABS) Circuit Diagram (Refer to 5 - BRAKES/ELECTRICAL - SCHEMATICS
AND DIAGRAMS).
1.
VISUALLY INSPECT COMPONENTS FOR DAMAGE AND CORRECT INSTALLATION
Visually inspect the BAS Travel Sensor for damage and correct installation.
Are there any visible BAS Travel Sensor concerns?
Yes >> Correct the sensor concerns as necessary.
Perform ABS VERIFICATION TEST.
No >> Go to 2
2.
MONITOR THE CAB MODULE WITH THE DRB III
With the DRB III , erase DTCs.
Start the engine.
With an assistant to drive, use the DRB III to monitor the CAB mod-
ule DTCs while performing road test.
Is the BAS Travel Sensor DTC set?
Yes >> Replace the BAS Travel Sensor. (Refer to 5 - BRAKES/
ELECTRICAL/TRAVEL SENSOR - REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Inspect and repair the related wiring harness for a possible
intermittent condition.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 267
POSSIBLE CAUSES