5 - 288
BRAKES - ABS ELECTRICAL DIAGNOSTICS
1202-BAS RELEASE SWITCH - PLAUSIBILITY ERROR (CONTINUED)
12.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE BAS RELEASE SWITCH SENSOR
(APPLIED) CIRCUIT WITH CAB CONNECTED
With the ignition off.
Reconnect the CAB harness connector.
Measure the resistance between ground and the BAS Release Switch
Sensor (Applied) circuit at the BAS Brake Booster C2 harness connec-
tor.
Is the resistance 6.5–7.0k ohms?
Yes
>> Replace the BAS Release Switch (Brake Booster). (Refer
to
5
-
BRAKE BOOSTER - REMOVAL)
Perform ABS VERIFICATION TEST.
No
>> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL)
Perform ABS VERIFICATION TEST.
BRAKES/HYDRAULIC/MECHANICAL/POWER
ANTILOCK
BRAKE
-
ZH