Chrysler 2005 Crossfire SRT6 Service Manual page 457

ZH
1210-CAB SYSTEM UNDERVOLTAGE (CONTINUED)
3.
MEASURE THE VOLTAGE OF THE FUSED B(+) CIRCUIT
Turn the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B(+) circuit at the CAB harness con-
nector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused B(+) circuit for an open.
Perform ABS VERIFICATION TEST.
4.
MEASURE THE VOLTAGE OF THE FUSED B(+) CIRCUIT
With the ignition on.
Measure the voltage of the Fused B(+) circuit at the CAB harness con-
nector.
Is the voltage above 10 volts?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the Fused B(+) circuit for an open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 291
ANTILOCK BRAKE -