Chrysler 2005 Crossfire SRT6 Service Manual page 418

5 - 252 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1173-STEERING ANGLE SENSOR - PLAUSIBILITY ERROR (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition On. The Controller Antilock Brake (CAB) monitors the status of the Steering
Angle Sensor.
• Set Condition: The Controller Antilock Brake (CAB) will set this DTC if the calculated steering angle offset is
out of the specified range.
IMPROPER WHEEL ALIGNMENT
IMPROPERLY MOUNTED STEERING ANGLE SENSOR
LOOSE STEERING ANGLE SENSOR
For a complete Antilock Brake System (ABS) Circuit Diagram (Refer to 5 - BRAKES/ELECTRICAL - SCHEMATICS
AND DIAGRAMS).
1.
VISUALLY INSPECT COMPONENTS FOR DAMAGE AND CORRECT INSTALLATION
Visually inspect the Steering Angle Sensor for damage and correct installation.
Are there any visible Steering Angle Sensor concerns?
Yes >> Correct the sensor concerns as necessary.
Perform ABS VERIFICATION TEST.
No >> Go to 2
2.
MONITOR THE CAB MODULE WITH THE DRB III
With the DRB III , erase DTCs.
Start the engine.
With an assistant to drive, use the DRB III to monitor the CAB mod-
ule DTCs while performing road test.
Is the Steering Angle Sensor DTC set?
Yes >> Replace the Steering Angle Sensor. (Refer to 5 -
BRAKES/ELECTRICAL/STEERING ANGLE SENSOR -
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Inspect and repair the related wiring harness for a possible
intermittent condition.
Perform ABS VERIFICATION TEST.
POSSIBLE CAUSES
ZH