Chrysler 2005 Crossfire SRT6 Service Manual page 428

5 - 262 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1185-BAS TRAVEL SENSOR CIRCUIT (CONTINUED)
8.
CHECK THE BAS TRAVEL SENSOR 5-VOLT SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the 5-Volt Supply circuit at the BAS Brake
Booster C1 harness connector.
Is the voltage below 1.0 volt?
Yes >> Go to 9
No >> Repair the 5-Volt Supply circuit for a short to voltage.
Perform ABS VERIFICATION TEST.
9.
MEASURE THE RESISTANCE BETWEEN THE BAS TRAVEL SENSOR 5-VOLT SUPPLY CIRCUIT AND THE
SENSOR GROUND CIRCUIT
Turn the ignition off.
Measure the resistance between the 5-Volt Supply circuit and the Sen-
sor Ground circuit.
Is the resistance above 100k ohms?
Yes >> Go to 10
No >> Repair the 5-Volt Supply circuit for a short to the Sensor
Ground circuit.
Perform ABS VERIFICATION TEST.
ZH