Chrysler 2005 Crossfire SRT6 Service Manual page 416

5 - 250 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1172-STEERING ANGLE SENSOR - INTERNAL ERROR (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on. The Controller Antilock Brake (CAB) monitors the status of the Steering
Angle Sensor.
• Set Condition: The Controller Antilock Brake (CAB) will set this DTC if the Steering Angle Sensor sends an
Internal Failure status to the CAB.
STEERING ANGLE SENSOR
For a complete Antilock Brake System (ABS) Circuit Diagram (Refer to 5 - BRAKES/ELECTRICAL - SCHEMATICS
AND DIAGRAMS).
1.
VISUALLY INSPECT COMPONENTS FOR DAMAGE AND CORRECT INSTALLATION
Visually inspect the Steering Angle Sensor for damage and correct installation.
Are there any visible Sensor concerns?
Yes >> Correct the sensor concerns as necessary.
Perform ABS VERIFICATION TEST.
No >> Go to 2
2.
MONITOR THE CAB WITH THE DRB III
With the DRB III , erase DTCs.
Start the engine.
With an assistant to drive, use the DRB III to monitor the CAB mod-
ule DTCs while performing road test.
Is the Steering Angle Sensor DTC set?
Yes >> Replace the Steering Angle Sensor. (Refer to 5 -
BRAKES/ELECTRICAL/STEERING ANGLE SENSOR -
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Inspect and repair the related wiring harness for a possible
intermittent condition.
Perform ABS VERIFICATION TEST.
POSSIBLE CAUSES
ZH