Download Print this page

GRAPHTEC FC8000 Series User Manual: Adjust Manually

Cutting pro.
Hide thumbs

Advertisement

Adjust Manually

This
section describes the operation to adjust with registration
mark scan by moving to registration mark manually after setting the
ARMS mode and POINTS.
Operation
Press the [2] key (MANUAL READ MARKS) in the ARMS
1
setting screen.
Following message is displayed.
Press the POSITION (¡ã¡å ? ? ) key and move the tool carriage
2
to the area to start scanning of the registration mark.
MARK TYPE1
Point
4
Point 1
(point to make
origin point)
Point
3
the tool inside this
area
Confrm the position of the tool, and if it is OK, press the [ENTER]
3
key.
Registration marks are scanned. Following message is displayed when
completed.
Next page
Point
2
Move the tool inside this
area
See "Automatically Adjust"
Press the [2] key (ARMS) in the MENU screen if it
is not ARMS setting screen.
POSITION
MARK TYPE2
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
Point
Point
2
4
Point 1
(point to make
origin point)
Point
3
It will return to ARMS setting screen (1/4) without
scanning when you press the [4] key (CANCEL).
5-36
Supplement
P .5-34
moving automatically to registration mark for
scanning.
Supplement
Supplement
Supplement
if you are

Advertisement

Troubleshooting

   Also See for GRAPHTEC FC8000 Series

   Related Manuals for GRAPHTEC FC8000 Series

Comments to this Manuals

Symbols: 0
Latest comments:
  • vincent cirillo Apr 28, 2016 12:49:
    HOW TO CHANGE CENTIMETER MEASURING UNITS TO INCHES MEASURING UNITS ON A GRAPHTEC FC 8000 SERIES PLOTTER