Adjust Manually - GRAPHTEC FC8000 SERIES User Manual

Adjust Manually

This section describes the operation to adjust with registration
mark scan by moving to registration mark manually after setting the
ARMS mode and POINTS.
Operation
1
Press the [2] key (MANUAL READ MARKS) in the ARMS
setting screen.
Following message is displayed.
2
Press the POSITION (▲▼◄►) key and move the tool carriage
to the area to start scanning of the registration mark.
Registration mark scan start area
MARK TYPE 1
Point
4
Point 1
(point to make
origin point)
Point
3
Move the tool inside this
area
3
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
R egistration marks are scanned. Following message is displayed when
completed.
Next page
Point
2
Move the tool inside this
area
POSITION
MARK TYPE 2
Point
Point
2
4
Point 1
(point to make
origin point)
Point
3
5-36
Supplement
See "Automatically Adjust" P.5-34
moving automatically to registration mark for
scanning.
Supplement
Press the [2] key (ARMS) in the MENU screen if it
is not ARMS setting screen.
Supplement
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
Supplement
It will return to ARMS setting screen (1/4) without
scanning when you press the [4] key (CANCEL).
if you are