Settings For Cutting; Setting Cutting Area - GRAPHTEC CE7000 Series User Manual

4.1

Settings for Cutting

Settings such as area and width of cutting, page length, mirrored, enlarged, shrunk, etc., can be set.

Setting cutting area

Origin point will be set at lower left of the AREA once the AREA is
set. It is possible to set the origin point at the center when the HP-
GL is selected.
Move the origin point to change the cutting position.
It will only cut within
this range
Operation
1
Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS screen (1/2) is displayed.
Upper right set
position
Origin
point
Image already cut
Supplement
•
See "Setting the Origin Point" about the
moving the origin point.
•
See "Setting Origin Point When HP-GL is
Set" for setting the origin point with HPGL
command.
Supplement
Perform the settings in Normal mode.
4-2