4 -
1
Settings for Cutting
Settings such as area and width of cutting, page length, mirrored, enlarged, shrunk, etc., can be set.
Setting Cutting Area
Origin point will be set at lower left of the AREA once the AREA is
set. It is possible to set the origin point at the center when the HP-
GL is selected.
Move the origin point to change the cutting position.
Supplement
For the front loading model, rotate the above figure 180 degrees.
Operation
1
Press the [MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/2) is displayed.
Next page
<For rear loading/sheet>
It will only cut
within this range
Upper right
set position
Origin point
Image already cut
4-2
Supplement
See "Setting the Origin Point"
l
the moving the origin point.
See"Setting Origin Point When HP-GL is Set"
l
P.3-9
for setting the origin point with HP-
GL command.
Supplement
See "How to Use Control Panel"
READY status.
P.3-7
about
P.2-17
for