Ip Access Control List (Acl) Commands (Gsm7248 Only); Section 14.8 "Ip Access Control List (Acl) Commands (Gsm7248 Only) - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Format
Mode
Rule Number
Action
Source MAC
Address
Destination MAC
Address
Ethertype
VLAN ID
COS
Assign Queue
Redirect
Interface
14.8 IP Access Control List (ACL) Commands (GSM7248
only)
This section describes the commands you use to configure IP ACL settings. IP ACLs
ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to IP ACLs:
• The 7200 Series Managed Switch does not support IP ACL configuration for IP
packet fragments.
• The maximum number of ACLs you can create is 100, regardless of type.
• The maximum number of rules per IP ACL is hardware dependent.
• If you configure a MAC ACL on an interface, you cannot configure an IP ACL on the
same interface.
Quality of Service (QoS) Commands
show mac access-lists [name]
Privileged EXEC
The ordered rule number identifier defined within the MAC
ACL.
Displays the action associated with each rule. The possible
values are Permit or Deny.
Displays the source MAC address for this rule.
Displays the destination MAC address for this rule.
Displays the Ethertype keyword or custom value for this rule.
Displays the VLAN identifier value or range for this rule.
Displays the COS (802.1p) value for this rule.
Displays the queue identifier to which packets matching this
rule are assigned.
Displays the unit/slot/port to which packets matching this
rule are forwarded.
v1.0, February 2007
14-35