Auto-Voice Over Ip Commands; Auto-Voip All - NETGEAR ProSafe GSM7228PS Cli Manual

Term Definition
Match All Indicates whether this access list applies to every packet. Possible values are True or
False.
Protocol The protocol to filter for this rule.
Source IP The source IP address for this rule.
Address
Source L4 Port The source port for this rule.
Keyword
Destination IP The destination IP address for this rule.
Address
Destination L4 The destination port for this rule.
Port Keyword
IP DSCP The value specified for IP DSCP.
Flow Label The value specified for IPv6 Flow Label.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The unit/slot/port to which packets matching this rule are copied.
Redirect The unit/slot/port to which packets matching this rule are forwarded.
Interface

Auto-Voice over IP Commands

This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands.
The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them
with a better class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an
interface, the interface scans incoming traffic for the following call-control protocols:
• Session Initiation Protocol (SIP)
• H.323
• Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest
CoS queue, which is generally used for time-sensitive traffic.

auto-voip all

Use this command to enable VoIP Profile on the interfaces of the switch.
Quality of Service (QoS) Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
6-48