Table of Contents
Advertisement
INSTALLATION REQUIREMENTS
3. INSTALLATION PROCEDURE
3.1 INSTALLATION REQUIREMENTS
3.1.1 ENVIRONMENT
1. Temperature Range:
2. Humidity Range:
3. Ambient Illumination:
4. Ventilation:
5. Ambient Dust:
6. If the place of installation is air-conditioned or heated, do not place the machine
where it will be:
1) Subjected to sudden temperature changes
2) Directly exposed to cool air from an air-conditioner
3) Directly exposed to heat from a heater
7. Do not place the machine where it will be exposed to corrosive gases.
8. Do not install the machine at any location over 2,000 m (6,500 feet) above sea
level.
9. Place the copier on a strong and level base.
10. Do not place the machine where it may be subjected to strong vibrations.
3.1.2 MACHINE LEVEL
1. Front to back:
2. Right to left:
The machine legs may be raised or lowered in order to level the machine. Set a
carpenter's level on the exposure glass.
SM
CÓPIA NÃO CONTROLADA
10°C to 32°C (50°F to 89.6°F)
15% to 80% RH
Less than 1,500 lux (do not expose to direct sunlight
or strong light)
Room air should turn over at least 3 times per hour
Less than 0.10 mg/m
Within 5 mm (0.2") of level
Within 5 mm (0.2") of level
3-1
CÓPIA NÃO CONTROLADA
3
-6
3
(2.7 x 10
oz/yd
)
A294/A295
Advertisement
Table of Contents
Troubleshooting
