5.6.6 DOWNLOADING STAMP DATA
The stamp data should be downloaded from the controller firmware to the hard
disks:
• When the machine is installed.
• After the hard disks have been replaced.
The print data contains the controller software, so execute SP5853 to download the
fixed stamp data required by the hard disks.
1. Enter the SP mode.
2. Select SP5853 then press "Execute". The following screen opens while the
stamp data is downloading.
The download is finished with the message prompts you to close.
3. Press the "Close" button then cycle the copier off and on again.
SM
PCcard -> ROM
Loading
Stamp Data
**_ _ _ _ _ _ _ _
Processing finished. Switch on the
main power switch.
Note: May re-set automatically.
Close
5-151
FIRMWARE UPDATE
B146S928.WMF
B146S929.WMF
B147/B149/B190