TRANSAXLE
CONTROL
7A
Change Lever Ball
Apply
a coating
of grease
to the bail seat surface,
and install the upper and lower ball seat, holder,
and
boot.
Note
Also apply grease to all joints.
Spring
Make sure that the hooked
part of spring
is properly
seated in the bracket
groove,
as shown in the figure.
Bracket Cavity
Put grease
in the bracket
cavity.
Change Control
Rod
Install the change
control
rod so that its relationship
with the change
lever is
as
shown
in the figure.
Tightening
torque:
16-22
N.m (1.6-2.3
m-kg, 12-17
ft-lb)
7A--83