Mazda 323 1988 Workshop Manual page 462

7A--38
6. Set the
SST
between the transaxle case and the
clutch housing, and install the
SST,
and tighten
to the specified torque.
Tightening torque:
18-20 N.m (1.8-2.0 m-kg, 13-14 f&lb)
Caution
Install the collars at the positions shown in the
figure.
.1
7. To seat the bearings, mount the
SST
on parts (A)
and (B) of the selector, and then turn the selector
so the gap shown by the arrow in the figure is
widened.
~.-._,"
Move the bar by hand until the selector can no
longer be turned, and then turn it in the reverse
direction until the gap (arrow) is eliminated.
8. Manually expand the selector for both sha.fts until
the selector no longer turns.
Caution
Make sure that each shaft gear turns
smoothly.