Mazda 323 1988 Workshop Manual page 850

14
BACK DOOR GLASS
Glass mark
A-A cross section
63"14X-06
2. Carefully clean and remove any grease from a 5
cm (1.97 in) wide area around the circumference
of the glass and the remaining bond on the body.
3. Bond a dam along the circumference of the glass
8 mm (0.31 in) from the edge.
Caution
Securely bond the dam and let it dry.
4. Apply primer with a brush to the circumference of
the glass and the body and it them to naturally dry
for 20 to 30 minutes.
Caution
Be sure not to allow dirt, water, oil, etc. to
come in contact with the coated surfaces and
do not touch it with your hand.
5. Install the spacers at the positions shown in the
figure.
Caution
Clips, with flaws, must be replaced.
6. When the primer has dried, apply an 11 mm (0.43
in) thick bead of repalr seal (BOO1 77 739) 5 mm
(0.20 in) from the periphery of the window glass
using a sealant gun.
Caution
Cut the nozzle of the repair seal cartridge as
illustrated in the figure.
If necessary, smooth the repair seal to correct
any irregularities.
14-28