Mazda 323 1988 Workshop Manual page 858

14
MOLDING
FRONT DRIP MOLDING
Removal and Installation
1, Remove the ,attaching screw of the front pillar.
2. Remove the ends of the roof rail and molding.
3. Remove the molding by twisting it so that the low-
er part of the molding is removed first. (Do not dam-
age the molding)
4. install in the reverse order of removal.
REAR DRIP MOLDING
Removal and Installation
I. Insert the tip of a standard screwdriver between
the roof rail and drip molding and lift the end of
the molding.
(Be careful not to scratch the molding)
2. Remove the molding by twisting with both hands,
beginning at the lower side.
3. Install in the reverse order of removal.
BELTLINE MOLDING
Removal and Installation
1, Pry up the clip at the end of the beltline molding.
2. Remove the sail outer garnish.
3. Remove the beltline molding mounting screw and
mounting rivet.
4. Lift the molding up to remove it.
5. Install in the reverse order of removal.
BELTLINE MOLDING (3 DOOR HATCHBACK)
Removal and lnstallatlon
I. Remove the quarter window glass.
2. Remove the weatherstrip.
3. Remove the beltline molding mounting screw, and
remove the molding.
4. Install in the reverse order of removal.
14-36