Mazda 323 1988 Workshop Manual page 654

9
REAR DIFFERENTIAL
1. Remove the propeller shaft (Refer to Section 8).
2. Remove the wheels
3. Put mating marks on the output shaft and
driveshaft, then remove the nut.
4. Remove the stabilizer from crossmember.
Caution
Never remove the both ends of the stabilizer.
5. Remove the lateral link.
Caution
Be careful that when disconnect the bolt and
nut, the lateral link will be bounded.
6. Remove the trailing link.
7. Pull the wheel hub out, and separate the driveshaft
from the output shaft.
8. Support the differential assembly with a jack, re-
move the assembly.