Mazda 323 1988 Workshop Manual page 582

ASSEMBLY /c;
Transfer Carrier
1, Coat both surfaces with sealant.
2. Install the transfer carrier assembly.
Tightening torque: 25-30 N.m
(2.5-3.1 m-kg, 18.1-22.4 ft-lb)
Note
Before coating with sealant, clean the contact
surfaces.
Front Differential Assembly
1, Assemble the center differential lock shift fork as-
sembly to the center differential assembly, and in-
stall the center differential assembly into the clutch
housing.
2.
install the set bolt.
Shaft Gear and Shift Fork Assembly
Install the primary shaft gear, secondary shaft gear,
and shift fork assembly according to the following
procedures:
1. Set the control end in olace.
2. Install the shift fork assembly on the secondary
shaft gear assembly.
3. Unite the primary shaft gear, secondary shaft gear
and shift fork assembly. Install the control rod into
the control end as the unit is lowered into place.
Note
Keep the assembly nearly vertical while in-
stalling.
KS-75