SA
ASSEMBLY
Flywheel
(MTX)
1. Tap the pilot bearing in with a suitable pipe and
,hammer.
2. Apply sealant to the flywheel bolts.
Caution
._~,Y
If reinstalling
flywheel
bolts, clean threads to
remove
old sealant, apply new sealant and
tighten to speclficatlon.
If old sealant
can not be removed,
replace
bolts.
3. install the flywheel, with the SST while tightening.
Tightening
torque:
96-103
N*m (9.6-10.6
m-kg, 71-76
ft-lb)
Drive Plate (ATX)
Install the drive plate along with the adapter and back-
ing plate with the SST.
Tightening
torque:
96-103
N.m (9.6-10.6
m-kg, 71-76
ft-lb)
Clutch Disc and Clutch Cover
Install the clutch disc and clutch cover with the SST,
and tighten the clutch cover.
Tightening
torque:
18-26
N*m (1.8-2.7
m-kg, 13-20
ft-lb)
Note
Follow the clutch disc Installation
directions
exactly (See Section 6).
Valve Seal
1. Apply engine oil to the inner surface of the new
valve seal.
2. Install the valve seal onto the valve guide with the
SST.
IA-58
323 Revised 10187