Mazda 323 1988 Workshop Manual page 822

13
REAR WHEEL ALIGNMENT
4WD:
(1) Loosen the adjusting rod lock nuts, then adjust
the toe-in.
(2) To increase the toe-in, turn the adjusting rods
as follows:
Right rod - Turn counterclockwise
Left rod - Turn clockwise
To decrease the toe-in, turn the adjusting rods
as follows:
Right rod - Turn clockwise
Left rod - Turn the rod counterclockwise
Caution
Both the left and right rods must be adjusted
by the same amount.
Note
One turn of the adjusting rod (both sides)
changes the toe-in by about 5.6 mm (0.22 in).
(3) Tighten the adjusting rod lock nuts to the speci-
fied torque.
Tightening torque:
55-64 N.m (5.6-6.5 m-kg, 41-47 ft-lb)
CAMBER
Inspection
The right rear hub spindle nut is a left-hand thread,
thus SST (49 8026 101) is used for the right side.
Use SST (49 8531 605) for the left side.
Camber angle: 2WD: O* 2%
4WD: -0'26' * 45'
13-24
323 Revised IO/87