Mazda 323 1988 Workshop Manual page 80

ASSEMBLY i A
No.1 cylinder
No.4 cylinder
Intake
xhaust
No.1 cylinder
No.4 cylinder
Intake
0 =',
A
I 0 0
w
r
r,
Exh:ust
I-"1
db i
No.1, 2 cylinder
(IN & EX)
Hydraulic Lash Adjuster (HLA) Hydraulic Lash Adjuster (HLA)
1. Pour engine oil into the oil reservoir in the rocker 1. Pour engine oil into the oil reservoir in the rocker
arm. arm. -
2. Apply engine oil to the new HLA. 2. Apply engine oil to the new HLA.
3. Install the HLA in the rocker arm. 3. Install the HLA in the rocker arm.
Caution
a) Do not remove the HLA from the rocker arm
unless necessary.
b)Be careful not to damage the O-ring when
installing.
Rocker Arm and Rocker Shaft Assembly
1. Assemble the rocker arm and rocker shaft assem-
bly as shown in the figure.
Caution
a) Be sure both rocker arm shaft oil holes face
downward.
b) The installation bolt holes are different for
the exhaust and intake sides as shown in
the figure.
Note
There are two types of rocker arms with differ-
ent offsets. The rocker arms used for No. 1
and No. 2 cylinder are the same for exhaust
and intake. No. 3 and No. 4 also use the same
rockers.
1 A-61