Mazda 323 1988 Workshop Manual page 448

7A
DISASSEMBLY
Clutch Hub Assembly (3rd - 4th gear)
Set the SST onto the 3rd gear, between the two sets
of teeth, and then, by using a press, remove the clutch
hub assembly together with the gear.
Caution
Hold the shaft with one hand so that it does
not fall.
Clutch Hub Assembly (1st - 2nd gear)
Support the 1st gear and press it and the clutch hub
assembly off the secondary shaft.
Caution
Hold the shaft with one hand so that it does
not fall.
Bearing Inner Race (drive pinion end of secon-
dary shaft gear)
Remove the bearing inner race from the shaft with
the SST.
Caution
Hold the shaft with one hand so that it does
not fall.
,'
7A-24