Mazda 323 1988 Workshop Manual page 61

IA
INSPECTION AND REPAIR
83Wl A -07
4
Angle: 1.5 mm (0.059 in) max.
Camshaft
1. Set the front and rear journals on V-blocks.
Check the camshaft runout, replace if necessary.
Runout: 0.03 mm (0.0012 in) max.
2. Check the cam for wear or damage, replace if
necessary.
3. Check the cam lobe height at the two places as
shown.
Height
IN
: 36.38-38.53
mm (1.432-1.438 in)
EX: 36.38-36.53 mm (1.432-l .438 in)
Minimum
IN : 36.23
mm (1.426 in)
EX: 36.23 mm (1.426 in)
4. Measure wear of the journals in X and Y directions
at the two places shown,
Diameter
Front and rear:
43.440-43.465
mm (1.7102-l .7112 in)
Center:
43.410-43.435 mm (1.7091-1.7100 in)
Out-of-round: 0.05 mm (0.002 in) max.