Mazda 323 1988 Workshop Manual page 495

ASSEMBLY
7A
10. Install the pipe (1) and the guide plate (2) and tem-
porarily tighten the bolts.
Nate
Set the spring as shown.
11. Install the change arm onto the change rod, and
secure it with the bolt.
Install the shift control rod and detent ball and
spring, and select neutral position.
12. Install the crankshaft lever and the crankshaft le-
ver shaft, and secure the shaft to the housing with
the pin.
13. Push and pull the change rod and move the guide
plate so that the selector moves smoothly in the
grooves of the guide plate. Then tighten the guide
plate mounting bolts.
14. Remove the control rod, ball, spring and pin.
Remove the crankshaft lever shaft and the crank-
shaft lever.
15. Install the funnel and the bearing outer race into
the secondary shaft gear bearing bore of the clutch
housing.
16. Install the oil seal and the bearing inner race into
the primary shaft gear bearing bore of the clutch
housing.
Transaxle Case
1. Install the oil passage and tighten the bolt.
2. Install the back-up light switch.
3. Install the selected adjust shim into the differential
side bearing bore of the transaxle case.
4. Tap the bearing outer race with a hammer handle
until it is flush with the end of the transaxle case.
5. Tap in the outer races until the edges contact the
clutch housing, using a piece of pipe (outer di-
ameter 68 mm (2.68 in) or less) and a hammer.
7A-71