Installation - Mazda 323 1988 Workshop Manual

DRIVESHAFT 9
-405
*3mmJ
I
(15.94 * 0.12
in)
Boot Band
1. Fold the band back by pulling on the end of the
band with pliers.
2. Lock the end of band by bending the locking clip.
Note
a) Always use a new band.
b)The band should be folded in the direction
opposite to the forward revolving direction
of the driveshaft.
After assembling the driveshaft, check the following:
1, Make sure the joint parts move smoothly in the
directions indicated by the arrows.
2. Check the boots for grease leaks or damage.
INSTALLATION
install
in
the reverse order of removal and be careful
of the following points:
Note
MTX and ATX are the Same procedure.
Dynamic Damper
Make sure the dynamic damper position is as shown
in the figure.
Note
When measuring the distance the ball joint is
fully pushed toward the driveshaft.
Clip
Before inserting the driveshaft
into the transaxle. make
sure the oil seals are free of any scratches. If there
are any problems, replace the oil seal.
(Refer to Section 7A)
Note
The clip should be replaced with a new one.
9-21