Mazda 323 1988 Workshop Manual page 573

7c
ASSEMBLY
Selector
1, Install the primary and secondary shaft bearing out-
er races into the transaxle case (shims removed).
2. After mounting the clutch housing onto the trans-
axle hanger, tap in the differential bearing outer
race with a hammer handle until it is flush with the
end of the clutch housing.
Next, position a piece of piece of pipe against the
outer race and tap in with a hammer until it con-
tacts the clutch housing.
,-__~,
Primary and Secondary Shaft Gear
1. As shown in the figure, put the outer races into the
SST.
Note
Turm the selector to eliminate the gap indi-
cated by the arrow in the figure.
2. Set the
SST
in place.
3. Mount the primary and secondary shaft gear as-
semblies to the
SST.
.-'
4. Set the
SST
between the transaxle case and the
clutch housing, and install the
SST,
and tighten
to the specified torque.
Tightening torque:
37-52 N.m (3.8-5.3 m-kg, 27-38 ft-lb)
._,
7C-66