Mazda 323 1988 Workshop Manual page 763

. -..-.. -.*n..- w.... I -
REMOVAL AND INSTALLATION
1. Remove the parts in the numbered sequence shown in the figure
2. Install in the reverse order of removal.
3. Take the following steps after installation:
(1) Check and adjust the push rod and piston clearance.
(2) Add fluid and bleed the air.
(3) Check all parts for fluid
leakage.
(4) Make an on-vehicle check of the unit.
(5) Check that the vacuum hose does not contact other parts.
Caution
Apply grease to the clevis pin.
1. Nut 4. Cotter
pin 7. Power-brake unit
2. Master cylinder 5. Clevis
pin
3. Vacuum hose 6. Nut
II-21