Mazda 323 1988 Workshop Manual page 575

7c
ASSEMBLY
-
(2) The shim to be used for the secondary shaft
gear should be selected by referring to the ta-
ble and selecting the shim which is nearest (on
the thick side) to the
value
obtained, by sub-
tracting the thickness of the diaphragm spring
which goes between the shim and the race,
from the measured value of the gap in the
selector.
Example: 0.94 mm (0.0370 in)
0.94 mm (0.0370 in) - 0.70 mm (0.0276 in)
[Dlaphragm spring]
= 0.24 mm (0.009 in)
So the nearest shim (on thick side) to 0.24 mm
(0.009 in) is 0.26 mm (0.010 In).
Note
The number of shims used must not be more
than two.
83UO7C.043
9. Remove the SST and then remove the transaxle
case, shaft gears and selectors.
IO. Remove the bearing
outer races
for both shafts
from the transaxle case.
Center Differential
1. install the center differential and bearing
outer race
2. Set the SST
in
place.
7C-66
r,
83"07C-102
323
Revised 10197